Ender3 v2: Difference between revisions

Latest revision as of 20:01, 24 July 2021

We got a new printer!!

install Cura 4.10.xx (newest version)
Add "New Printer" and choose Ender3 (in older version just choose any rectangular and edit the print size)
Start with the pre-made settings or use dusjagr's "optimized" curaprofiles for draft (0.2mm) or fine (0.12mm)

That's kinda the easiest and sofar gave me the best results.

Login with: mechartlab / MECHARTLAB WIFI KEY (check on whiteboard).

Choose Port:

Choose Profile:

Connect

To Do:

it's kinda working with the cura settings. but print quality not so good still....

@@ Line 1: / Line 1: @@
 We got a new printer!!
+[[File:Ender3_v2.jpg|thumb|400px]]
+== Slice yourself using CURA ==
+* install Cura 4.10.xx (newest version)
+* Add "New Printer" and choose Ender3 (in older version just choose any rectangular and edit the print size)
+* Start with the pre-made settings or use dusjagr's "optimized" curaprofiles for draft (0.2mm) or fine (0.12mm)
+[[:File:Ender3-CuraProfiles.zip]]
+[[File:CuraSetting_ender3V2.jpg|600px]]
+== Print from microSD card ==
+That's kinda the easiest and sofar gave me the best results.
+== Bed leveling for Ender 3 V2 ==
+Check this movie: https://www.youtube.com/watch?v=4JSa_r8xgX8
+== Connect via OctoPrint ==
+Installed on OctoPrint. try this: http://octopi.local/ or: http://192.168.1.38/
+Login with: mechartlab / MECHARTLAB WIFI KEY (check on whiteboard).
+Choose Port:
+* '''/dev/ttyUSB0 for Ender3'''
+* /dev/ttyACM0 for [[MicroDelta]] aka RandeDelta
+Choose Profile:
+* '''Neue Ender Siech im MechArtLab'''
+* RandeDelta
+'''Connect'''
+=== upload gcode ===
+* Upload your gcode
+* Start to Print!!!
+'''To Do:'''
+* Upload to SD card notworking
+* Multiple printers on OctoPi
+* add LEDs!!
+=== Slice on OctoPrint (experimental) ===
+used this instruction: https://www.youtube.com/watch?v=0I_BIR36Grk
+it's kinda working with the cura settings. but print quality not so good still....
+[[File:Ender3_OctoPrintSlicing.jpg|640px]]