Ender3
Slice yourself using CURA
Print from microSD card
Connect via OctoPrint
Installed on OctoPrint. try this: http://octopi.local/ or: http://192.168.1.38/
Login with: mechartlab / MECHARTLAB WIFI KEY (check on whiteboard).
Choose Port:
- /dev/ttyUSB0 for Ender3
- /dev/ttyACM0 for MicroDelta aka RandeDelta
Choose Profile:
- Neue Ender Siech im MechArtLab
- RandeDelta
Connect
upload gcode
To Do:
Upload to SD card notworking
Slice on OctoPrint (experimental)
used this instruction: https://www.youtube.com/watch?v=0I_BIR36Grk
it's kinda working with the cura settings. but print quality not so good still....