Krabbenarm: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
| Line 2: | Line 2: | ||
===Downloads=== | ===Downloads=== | ||
*Sketchup Model (SKP): [[File:Krabbenarm20200803.zip]] | *Sketchup Model (SKP): [[File:Krabbenarm20200803.zip]] | ||
*Laser Cut File (DXF) [[File:Krabbenarm-Laser.dxf]] | *Laser Cut File (DXF) [[File:Krabbenarm-Laser.dxf]] - 5mm MDF | ||
===Material=== | ===Material=== | ||
* 12 lasercut wood parts | * 12 lasercut wood parts - 5mm MDF | ||
* 6 wood balls (20mm diameter) | * 6 wood balls (20mm diameter) | ||
* 4 dowels 6 x 30mm | * 4 dowels 6 x 30mm | ||
| Line 38: | Line 38: | ||
==Krabbenarm - Accessories== | ==Krabbenarm - Accessories== | ||
===Cable holder=== | ===Cable holder=== | ||
Laser File (DXF): [[File:KrabbenarmCableholder-Laser.dxf]] | Laser File (DXF): [[File:KrabbenarmCableholder-Laser.dxf]] - 5mm MDF | ||
[[File:KrabbenarmCableholder.png|300px]] | [[File:KrabbenarmCableholder.png|300px]] | ||
Revision as of 11:49, 3 August 2020
Krabbenarm - Base
Downloads
- Sketchup Model (SKP): File:Krabbenarm20200803.zip
- Laser Cut File (DXF) File:Krabbenarm-Laser.dxf - 5mm MDF
Material
- 12 lasercut wood parts - 5mm MDF
- 6 wood balls (20mm diameter)
- 4 dowels 6 x 30mm
- 3 screws M5 x 30
- 3 wing nuts M5
- 40cm teflon tube 4mm diameter
- neodym magnet 15 x 3mm
Assembly
Drill 6mm holes ca 8mm into one side of each ball and glue dowels:
Glue toolholder with epoxy (Araldite...): ball, dowel, tubeholder, magnet: south pole facing outwards
Glue base plate
Sand all wooden parts, spray paint at will
Screw moving segments together loosely
Push Solder through hole in base and through teflon tube
Assemble all parts
Krabbenarm - Accessories
Cable holder
Laser File (DXF): File:KrabbenarmCableholder-Laser.dxf - 5mm MDF
PCB holder
Laser Cut file : File:KrabbenarmPCBHolder-Laser.dxf - 5mm MDF
