Krabbenarm: Difference between revisions
Jump to navigation
Jump to search
| Line 12: | Line 12: | ||
* neodym magnet 15 x 3mm | * neodym magnet 15 x 3mm | ||
===Assembly=== | ===Assembly=== | ||
Drill 6mm holes ca 8mm into one side of each ball and glue dowels: | |||
[[File: ballsndowls.png|300px|right]] | |||
Glue toolholder with epoxy (Araldite...): ball, dowel, tubeholder, magnet: south pole facing outwards | |||
[[File:KrabbenarmToolholder|300px|right]] | |||
Glue base plate | |||
[[File:KrabbenarmBaseplate.png|300px]] | |||
Sand all wooden parts, spray paint at will | |||
Screw moving segments together loosely | |||
[[File:KrabbenarmSegment.png|300px]] | |||
Push Solder through hole in base and through teflon tube | |||
Assemble all parts | |||
[[File:Screenshot 2020-08-03 at 11.07.16.png|300px]] | |||
==Krabbenarm - Accessories== | ==Krabbenarm - Accessories== | ||
Revision as of 11:13, 3 August 2020
Krabbenarm - Base
Downloads
- Sketchup Model (SKP): File:Krabbenarm20200803.zip
- Laser Cut File (DXF) File:Krabbenarm-Laser.dxf
Material
- 12 lasercut wood parts
- 6 wood balls (20mm diameter)
- 4 dowels 6 x 30mm
- 3 screws M5 x 30
- 3 wing nuts M5
- 40cm teflon tube 4mm diameter
- neodym magnet 15 x 3mm
Assembly
Drill 6mm holes ca 8mm into one side of each ball and glue dowels:
Glue toolholder with epoxy (Araldite...): ball, dowel, tubeholder, magnet: south pole facing outwards
Glue base plate
Sand all wooden parts, spray paint at will
Screw moving segments together loosely
Push Solder through hole in base and through teflon tube
Assemble all parts
