Krabbenarm: Difference between revisions
Jump to navigation
Jump to search
| Line 13: | Line 13: | ||
===Assembly=== | ===Assembly=== | ||
#Drill 6mm holes ca 8mm into one side of each ball and glue dowels:[[File: ballsndowls.png|300px|right]] | #Drill 6mm holes ca 8mm into one side of each ball and glue dowels:[[File: ballsndowls.png|300px|right]] | ||
#Glue toolholder with epoxy (Araldite...): ball, dowel, tubeholder, magnet: south pole facing outwards[[File:KrabbenarmToolholder|300px|right]] | #Glue toolholder with epoxy (Araldite...): ball, dowel, tubeholder, magnet: south pole facing outwards [[File:KrabbenarmToolholder|300px|right]] | ||
#Glue base plate [[File:KrabbenarmBaseplate.png|300px]] | #Glue base plate [[File:KrabbenarmBaseplate.png|300px]] | ||
#Sand all wooden parts, spray paint at will | #Sand all wooden parts, spray paint at will | ||
Revision as of 11:12, 3 August 2020
Krabbenarm - Base
Downloads
- Sketchup Model (SKP): File:Krabbenarm20200803.zip
- Laser Cut File (DXF) File:Krabbenarm-Laser.dxf
Material
- 12 lasercut wood parts
- 6 wood balls (20mm diameter)
- 4 dowels 6 x 30mm
- 3 screws M5 x 30
- 3 wing nuts M5
- 40cm teflon tube 4mm diameter
- neodym magnet 15 x 3mm
Assembly
- Drill 6mm holes ca 8mm into one side of each ball and glue dowels:
- Glue toolholder with epoxy (Araldite...): ball, dowel, tubeholder, magnet: south pole facing outwards
File:KrabbenarmToolholder - Glue base plate
- Sand all wooden parts, spray paint at will
- Screw moving segments together loosely
- Push Solder through hole in base and through teflon tube
- Assemble all parts
