Krabbenarm: Difference between revisions
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
==Krabbenarm - Base== | ==Krabbenarm - Base== | ||
Sketchup Model: [[File:Krabbenarm20200803.zip]] | |||
===Material=== | ===Material=== | ||
* 12 lasercut wood parts: [[File:Krabbenarm-Laser.dxf]] | * 12 lasercut wood parts: [[File:Krabbenarm-Laser.dxf]] | ||
| Line 11: | Line 12: | ||
#Drill 6mm holes ca 8mm into one side of each ball and glue dowels: | #Drill 6mm holes ca 8mm into one side of each ball and glue dowels: | ||
[[File: ballsndowls.png|300px]] | [[File: ballsndowls.png|300px]] | ||
#Glue toolholder with epoxy (Araldite...): ball, dowel, tubeholder, magnet | #Glue toolholder with epoxy (Araldite...): ball, dowel, tubeholder, magnet: south pole facing outwards | ||
[[File:KrabbenarmToolholder|300px] | |||
#Glue base plate | |||
[[File:KrabbenarmBaseplate.png|300px]] | |||
#Sand all wooden parts, spray paint at will | |||
#Screw moving segments together loosely | |||
[[File:KrabbenarmSegment.png|300px] | |||
==Krabbenarm - Accessories== | ==Krabbenarm - Accessories== | ||
Revision as of 11:00, 3 August 2020
Krabbenarm - Base
Sketchup Model: File:Krabbenarm20200803.zip
Material
- 12 lasercut wood parts: File:Krabbenarm-Laser.dxf
- 6 wood balls (20mm diameter)
- 4 dowels 6 x 30mm
- 3 screws M5 x 30
- 3 wing nuts M5
- 40cm teflon tube 4mm diameter
- neodym magnet 15 x 3mm
Assembly
- Drill 6mm holes ca 8mm into one side of each ball and glue dowels:
- Glue toolholder with epoxy (Araldite...): ball, dowel, tubeholder, magnet: south pole facing outwards
[[File:KrabbenarmToolholder|300px]
- Glue base plate
- Sand all wooden parts, spray paint at will
- Screw moving segments together loosely
[[File:KrabbenarmSegment.png|300px]