SinkDriverArduinoShield: Difference between revisions
Jump to navigation
Jump to search
(→Print) |
(→Print) |
||
| Line 23: | Line 23: | ||
* Driven Connectors: 3.5mm: 2 x 8 pins, 4 pins (RP023xxHBWC) | * Driven Connectors: 3.5mm: 2 x 8 pins, 4 pins (RP023xxHBWC) | ||
* Power Connector: HEBW 21 (bei reichelt.de) | * Power Connector: HEBW 21 (bei reichelt.de) | ||
* Printtaster/Kurzhubtaster | * Reset Printtaster/Kurzhubtaster | ||
* Jumper for internal power selection | |||
Revision as of 16:32, 25 December 2013
Information
This was a project for a Mosfet power driver shield for an arduino. The driver provides a sink source / is driven to ground. It was originally used with MaxMSP or PD, and used to drive solenoids, so it has protection diodes. SMD-parts required!
Schematic (single channel)
File:ArduinoPOWERshield-PCB.zip
Parts:
- Mosfet: IRF510
- LED: any in reverse mount (SMD PLCC2)
- Resistors: 1k and 100k (SMD 1206)
- Diode: 1n4001 (SMD)
- Arduino Connectors 2.54mm: 6 pins, 2x8 pins, 10 pins
- Driven Connectors: 3.5mm: 2 x 8 pins, 4 pins (RP023xxHBWC)
- Power Connector: HEBW 21 (bei reichelt.de)
- Reset Printtaster/Kurzhubtaster
- Jumper for internal power selection