User:Aaron: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 7: | Line 7: | ||
I recommend [https://www.prusa3d.com/page/prusaslicer_424/ Prusa Slicer.] | I recommend [https://www.prusa3d.com/page/prusaslicer_424/ Prusa Slicer.] | ||
* Install latest Prusa Slicer | * Install latest Prusa Slicer | ||
* Add Printer | * Add Printer: Other Vendors, Creality, Ender 3 BL-Touch | ||
[[File:Prusa_Slicer_Printer_Preset-Selection-Ender3_BL-Touch.png|thumb|none]] | |||
* Add Physical Printer: | |||
[[File:Prusa_Slicer_Printer_Preset-Selection-Ender3_BL-Touch.png|thumb|none]] | |||
Firmware-Type: Klipper | |||
* Double check Nozzle Size. 0.8mm at the moment. | |||
* IP Adress: 172.31.33.57 | |||
* Double check Nozzle Size. 0.8mm at the moment. | * Double check Nozzle Size. 0.8mm at the moment. | ||
Revision as of 15:39, 20 September 2023
Coconut 2 Klipper
The Ender 3 has been upgraded with a BL-Touch Leveling sensor. It's running the Custom Firmware Klipper. This way, it's being controlled by the Raspberry Pi in the Displaycase next to it. This gives us a nice touch screen interface and allows it to print faster and more accurate.
Slicer
I recommend Prusa Slicer.
- Install latest Prusa Slicer
- Add Printer: Other Vendors, Creality, Ender 3 BL-Touch
- Add Physical Printer:
Firmware-Type: Klipper
- Double check Nozzle Size. 0.8mm at the moment.
- IP Adress: 172.31.33.57
- Double check Nozzle Size. 0.8mm at the moment.