SinkDriverArduinoShield: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
m (moved PowerSinkDriverArduinoShield to SinkDriverArduinoShield: shorter title) |
||
| (9 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
= Information = | |||
This was a project for a Mosfet power driver shield for an arduino. The driver provides a sink source / is driven to ground. It was originally used with MaxMSP or PD, and used to drive solenoids, so it has protection diodes. SMD-parts required! | This was a project for a Mosfet power driver shield for an arduino. The driver provides a sink source / is driven to ground. It was originally used with MaxMSP or PD, and used to drive solenoids, so it has protection diodes. SMD-parts required! | ||
[[File:ArduinoPOWERshield-2.jpg]] | [[File:ArduinoPOWERshield-2.jpg]] | ||
[[File:ArduinoPOWERshield-3.jpg]] | [[File:ArduinoPOWERshield-3.jpg]] | ||
= Schematic (single channel) = | |||
[[File:ArduinoPOWERshield-4.png]] | [[File:ArduinoPOWERshield-4.png]] | ||
= Print = | |||
[[File:ArduinoPOWERshield-PCB.zip]] | [[File:ArduinoPOWERshield-PCB.zip]] | ||
Parts: | |||
* Mosfet: 14x IRF510 | |||
* LED: 14x any in reverse mount (SMD PLCC2) | |||
* Resistors: 14x 1k and 100k (SMD 1206) | |||
* Diode: 14x 1n4001 (SMD) | |||
* Arduino Connectors 2.54mm: 6 pins, 2x 8 pins, 10 pins | |||
* Driven Connectors: 3.5mm: 2x 8 pins, 4 pins (RP023xxHBWC) | |||
* Power Connector: HEBW 21 (bei reichelt.de) | |||
* Reset Printtaster/Kurzhubtaster | |||
* Jumper for power selection | |||
Don't forget the solder bridges! | |||
Latest revision as of 17:50, 1 January 2014
Information
This was a project for a Mosfet power driver shield for an arduino. The driver provides a sink source / is driven to ground. It was originally used with MaxMSP or PD, and used to drive solenoids, so it has protection diodes. SMD-parts required!
Schematic (single channel)
File:ArduinoPOWERshield-PCB.zip
Parts:
- Mosfet: 14x IRF510
- LED: 14x any in reverse mount (SMD PLCC2)
- Resistors: 14x 1k and 100k (SMD 1206)
- Diode: 14x 1n4001 (SMD)
- Arduino Connectors 2.54mm: 6 pins, 2x 8 pins, 10 pins
- Driven Connectors: 3.5mm: 2x 8 pins, 4 pins (RP023xxHBWC)
- Power Connector: HEBW 21 (bei reichelt.de)
- Reset Printtaster/Kurzhubtaster
- Jumper for power selection
Don't forget the solder bridges!