Difference between revisions of "Ender3"

From SGMK-SSAM-WIKI
Jump to: navigation, search
(upload gcode)
(Connect via OctoPrint)
 
Line 38: Line 38:
  
 
* Upload to SD card notworking
 
* Upload to SD card notworking
 +
* Multiple printers on OctoPi
 +
* add LEDs!!
  
 
=== Slice on OctoPrint (experimental) ===
 
=== Slice on OctoPrint (experimental) ===

Latest revision as of 12:32, 11 April 2019

Ender3 MechArtLab.jpg

Slice yourself using CURA

  • install Cura 4.0.xx (newsest version)
  • Add "New Printer" and choose Ender3 (in older version just choose any rectangular and edit the print size)
  • Start with the pre-made settings or use dusjagr's "optimized" curaprofiles for draft (0.2mm) or fine (0.1mm)

File:Ender3-CuraProfiles.zip

MachineSettings Ender3.png

Print from microSD card

That's kinda the easiest and sofar gave me the best results.

Connect via OctoPrint

Installed on OctoPrint. try this: http://octopi.local/ or: http://192.168.1.38/

Login with: mechartlab / MECHARTLAB WIFI KEY (check on whiteboard).

Choose Port:

  • /dev/ttyUSB0 for Ender3
  • /dev/ttyACM0 for MicroDelta aka RandeDelta

Choose Profile:

  • Neue Ender Siech im MechArtLab
  • RandeDelta

Connect

upload gcode

  • Upload your gcode
  • Start to Print!!!

To Do:

  • Upload to SD card notworking
  • Multiple printers on OctoPi
  • add LEDs!!

Slice on OctoPrint (experimental)

used this instruction: https://www.youtube.com/watch?v=0I_BIR36Grk

it's kinda working with the cura settings. but print quality not so good still....

Ender3 OctoPrintSlicing.jpg