Ender3

Slice yourself using CURA

• install Cura 4.0.xx (newsest version)
• Add "New Printer" and choose Ender3 (in older version just choose any rectangular and edit the print size)
• Start with the pre-made settings or use dusjagr's "optimized" curaprofiles for draft (0.2mm) or fine (0.1mm)

File:Ender3-CuraProfiles.zip

Print from microSD card

That's kinda the easiest and sofar gave me the best results.

Connect via OctoPrint

Installed on OctoPrint. try this: http://octopi.local/ or: http://192.168.1.38/

Login with: mechartlab / MECHARTLAB WIFI KEY (check on whiteboard).

Choose Port:

• /dev/ttyUSB0 for Ender3
• /dev/ttyACM0 for MicroDelta aka RandeDelta

Choose Profile:

• Neue Ender Siech im MechArtLab
• RandeDelta

Connect

upload gcode

To Do:

Upload to SD card notworking

Slice on OctoPrint (experimental)

used this instruction: https://www.youtube.com/watch?v=0I_BIR36Grk

it's kinda working with the cura settings. but print quality not so good still....