SinkDriverArduinoShield

From SGMK-SSAM-WIKI
Jump to: navigation, search

Information

This was a project for a Mosfet power driver shield for an arduino. The driver provides a sink source / is driven to ground. It was originally used with MaxMSP or PD, and used to drive solenoids, so it has protection diodes. SMD-parts required!

ArduinoPOWERshield-2.jpg ArduinoPOWERshield-3.jpg


Schematic (single channel)

ArduinoPOWERshield-4.png

Print

File:ArduinoPOWERshield-PCB.zip

Parts:

  • Mosfet: 14x IRF510
  • LED: 14x any in reverse mount (SMD PLCC2)
  • Resistors: 14x 1k and 100k (SMD 1206)
  • Diode: 14x 1n4001 (SMD)
  • Arduino Connectors 2.54mm: 6 pins, 2x 8 pins, 10 pins
  • Driven Connectors: 3.5mm: 2x 8 pins, 4 pins (RP023xxHBWC)
  • Power Connector: HEBW 21 (bei reichelt.de)
  • Reset Printtaster/Kurzhubtaster
  • Jumper for power selection

Don't forget the solder bridges!